Specifications

RL-TS Series Operation Manual 65
29B6.1 Outputting to a Printer
By connecting a printer to the balance, span adjustment and span test results and measurement results can be
printed in ISO/GLP/GMP compliant form.
For printing examples, refer to “Appendix 3: Printing in Compliance with ISO/GLP/GMP”
(P.
X91X).
58BConnecting a printer
By using the D-SUB9P cable, connect the RS-232C connector of the balance to a printer.
The printers that can be connected to the balance are CSP-160 and CSP-240.
For the printer, the following setting is required. Set the following by referring to the operation manual of
the printer.
- Set the printing function (printing control) to “balance control.”
- Make the baud rate and other communication settings compatible with the settings made in the balance.
The date and time data set in the printer is also printed. Before printing, set the date and
time in the printer.
59BPrinting span adjustment and span test results
1
Set to the function setting mode.
(Refer to “Section 2-5: Function Setting
Basics (P.
X22X).)
Press and hold the [Function] key. After
“Func” is displayed, release the finger.
2
Press the [Function] key several times to select
“E.GLP.”
Select “1” by pressing the [Zero/Tare] key.
3
Press the [Function] key several times to select
“E1.C.o.”
Select “1” by pressing the [Zero/Tare] key.
4
Save the setting. Press the [Target] key.
The balance goes back to normal display.
Reference