Troubleshooting guide

Indicator Installation and Configuration 7
4.0 Indicator Installation and Configuration
4.1 Indicator Installation
The Summit SB-1000 Bariatric Wheelchair Scale has several connections on the back of the indicator.
Connection points include:
• AC power connection
• RS-232 port connection
• Scale connection port
• Adaptor storage connection
AC Power Connection
The Summit SB-1000 Scale has a 120 VAC adaptor or 230 VAC adaptor to use when power is readily available.
The AC power adaptor plugs into the back of the indicator as shown in
Figure 4-1. The AC adaptor, when not in
use, plugs into the back housing of the indicator. Figure 4-1 illustrates that location.
Figure 4-1. AC Power and RS-232 Connection Site with Back Plastic Cover in Place
The Summit SB-1000 Scale is capable of running its internal sealed lead-acid rechargeable battery if no
additional power source is available. Battery life is approximately 75 hours. If the
LO Bat indicator is showing on
the display, recharge the battery or connect the scale to an AC power source as soon as possible for accurate
weighing.
Battery Charging
When the AC adaptor is connected to a power source, the rechargeable battery goes into recharge mode. The
LED indicator light on the back of the scale housing will illuminate red during the charging period, and change
over to green when the battery becomes fully charged.
Connect AC power
source here
LED indicator light
illuminates from red to
green when charged
Store the 120 VAC
adaptor here when not
in use
Removable screws
RS-232 port connection
Store the 230 VAC adaptor
here when not in use