Specifications
Table Of Contents
- 1.0 Introduction
- 2.0 Mounting Plate Installation and Setup
- 3.0 Configuration
- 3.1 Auto-Learn
- 3.2 Manual Configuration
- 3.3 Serial Communications
- 3.4 Testing the Remote Display
- 3.4.1 Display
- 3.4.2 Digital Outputs
- 3.4.3 Digital Inputs
- 3.4.4 Loop Back
- 3.5 Version
- 3.6 Demand Print Displaying
- 3.7 Serial Commands
- 3.7.1 Command Format (7-Segment):
- 3.7.2 Display Message Command Format (Matrix Display):
- 3.7.3 Set or Get the Digital I/O
- 4.0 Options
- 5.0 Appendix
2 LaserLight Remote Display Installation & Operation Manual
1.1 Annunciators
The 7-segment LaserLight remote display uses a set of four high-intensity LED annunciators (shown in
Figure 1-1) and the matrix display uses two positions of the di
splay to show arrows (shown in Figure 1-2) which
provide additional information about
the value being displayed:
•
Gross and Net annunciators are lit to show whether the displayed weight is a gross or net weight.
•
lb, kg annunciators indicate the units associated with the displayed value and represent primary and
secondary units.
• Red, green circle and green arrow annunciators indicate the
traffic light state on the display. This feature
applies to only the LaserLight 4-SG.
Figure 1-1. 7-Segment Front Panel Display
Figure 1-2. Matrix Display Front Panel
LED
annunciators
Optional traffic
light display
Arrow
annunciators