Specifications
Table Of Contents
- 1.0 Introduction
- 2.0 Mounting Plate Installation and Setup
- 3.0 Configuration
- 3.1 Auto-Learn
- 3.2 Manual Configuration
- 3.3 Serial Communications
- 3.4 Testing the Remote Display
- 3.4.1 Display
- 3.4.2 Digital Outputs
- 3.4.3 Digital Inputs
- 3.4.4 Loop Back
- 3.5 Version
- 3.6 Demand Print Displaying
- 3.7 Serial Commands
- 3.7.1 Command Format (7-Segment):
- 3.7.2 Display Message Command Format (Matrix Display):
- 3.7.3 Set or Get the Digital I/O
- 4.0 Options
- 5.0 Appendix
Appendix 29
5.0 Appendix
5.1 Error Messages
The LaserLight remote display provides several error messages. When an error occurs, the message is shown on
the display.
NOTE: Some of the actual error messages displayed by the remote display are cryptic and are represented in Table 5-1
as closely as possible with plain text.
Table 5-1 lists error messages shown by the LaserLight remote display and their meaning.
5.2 7-Segment Display Replacement Parts
Table 5-2 lists selected replacement parts for the LaserLight remote displays.
7-Segment
Display
Message
Matrix Display
Message
8-Character
Matrix Display
Message
12-Character Meaning Cause
LError LError Learn Error Auto Learn error Auto Learn failed
WError WError Write Error Indicator code Write error. Could not save menu settings to the serial
EEPROM
Reset Reset Reset Config Invalid settings Invalid settings upon power up. A
ll settings reset to their
default state.
RError RError Range Error Range Error When the Rice Lake format goes over or under range.
Table 5-1. Error Messages
Reference Number Part Number Description Model Figure Number
--- 40672 Ground wire, 9 inch (1) 4" model Figure 5-3 33
--- 72992 Enclosure, steel (1)
26 72993 Plate, bottom gusset (1)
30 75848 Component plate, vertical (1)
31 74880 Primary display board (1)
32 74881 Secondary display board (1)
34 76246 6-position cable (1) Figure 5-2 32
--- 72995 Lens, optically filtering (1)
49 72994 Gasket, mounting plate (1)
Table 5-2. Selected Replacement Parts