Specifications

24 LaserLight Remote Display Installation & Operation Manual
4.0 Options
There are several options available with the LaserLight remote display. They include:
• Time and date
• Temperature
NOTE: The Time-Date and Temperature options display in three-second cycles (along with weight) when
displayed weight is zero or below.
• Field installable visor
• Pole mount kit
• Traffic light option
4.1 Time and Date
The time and date option can be either factory installed or can be ordered at a later date. Figure 4-1 shows the
location of the time and date option.
Figure 4-1. LaserLight Bottom Enclosure
If the time and date option (PN 75853) is added after initial installation, see Section 2.0 for enclosure
disassembly instructions. To install the this option, cut the adhesive labels from the option holes and install the
time and date switch assembly.
Attach time and date wiring to J7 on the CPU board.
4.2 Temperature
If the temperature option (PN 43412) is added after initial installation, see Section 2.0 for enclosure disassembly
instructions. To install the this option, remove the plug from the option hole and insert the temperature probe.
Attach temperature probe wiring to J4 on the CPU board.
4.3 Visor Installation
An optional visor can be installed on the LaserLight 7-segment remote display and the 8- or 12-character matrix
display. Figure 4-2 shows the remote display with
the optional visor installed.
Figure 4-2. LaserLight Remote Display w/ Optional Visor Installed (7-Segment Display)
Set the visor (PN 75854 - 4" model & the 8-character matrix display) or (PN 75855 - 6" model & the
12-character matrix display) on top of the remote display and attach the visor using screws and plastic washers
provided.
Time & Date Set
Light Probe
Learn Switch
Temperature Probe
Membrane Vent