Specifications
Table Of Contents
- 1.0 Introduction
- 2.0 Mounting Plate Installation and Setup
- 3.0 Configuration
- 3.1 Auto-Learn
- 3.2 Manual Configuration
- 3.3 Serial Communications
- 3.4 Testing the Remote Display
- 3.4.1 Display
- 3.4.2 Digital Outputs
- 3.4.3 Digital Inputs
- 3.4.4 Loop Back
- 3.5 Version
- 3.6 Demand Print Displaying
- 3.7 Serial Commands
- 3.7.1 Command Format (7-Segment):
- 3.7.2 Display Message Command Format (Matrix Display):
- 3.7.3 Set or Get the Digital I/O
- 4.0 Options
- 5.0 Appendix
18 LaserLight Remote Display Installation & Operation Manual
Serial Menu
Port 1 Parameter Choices Description
Level 3 submenus
BAUD 1200
2400
4800
9600
19200
Baud rate. Selects the transmission speed for Port 1
PARITY ODD
EVEN
NONE
Selects the parity of data transmitted from Port 1
DATA BITS 7
8
Selects the number of data bits transmitted from Port 1
STOP BITS 1
2
Selects the number of stop bits transmitted from Port 1
ECHO ON
OFF
Enable this feature to allow echoing between the remote display and other
devices. If enabled and echoing, the baud settings must be set equal to or
greater than the device being echoed to.
LOCK OFF
ON
If this parameter is disabled, the ec
ho port display uses the same
communications settings as the indicator port after an Auto-Learn is run.
Table 3-6. Port 1 Serial Menu Parameters