Specifications
Table Of Contents
- 1.0 Introduction
- 2.0 Mounting Plate Installation and Setup
- 3.0 Configuration
- 3.1 Auto-Learn
- 3.2 Manual Configuration
- 3.3 Serial Communications
- 3.4 Testing the Remote Display
- 3.4.1 Display
- 3.4.2 Digital Outputs
- 3.4.3 Digital Inputs
- 3.4.4 Loop Back
- 3.5 Version
- 3.6 Demand Print Displaying
- 3.7 Serial Commands
- 3.7.1 Command Format (7-Segment):
- 3.7.2 Display Message Command Format (Matrix Display):
- 3.7.3 Set or Get the Digital I/O
- 4.0 Options
- 5.0 Appendix
14 LaserLight Remote Display Installation & Operation Manual
3.3 Serial Communications
The LaserLight remote display has two serial ports available:
• Port 0 - Provides communication with the indicator
• Port 1 - Provides echoing OF INDICATOR DATA
There are 15 sub-parameters associated with Port 0 and s
ix sub-parameters associated with Port 1 which are
shown in Figure 3-6 on page 15. See Section 2.4.2 for serial wiring positions.
Parameter Choices Description
Level 3 submenus (TIMDAT Parameter)
ENABLE On
Off
Select On to enable time and date option.
Note: You need an additional chip
called a “snap hat.” It is recommended that you disable the time/date feature if
you don’t want this addtional chip. Will display at zero or less weight only.
FORMAT USA
ISO
Displays in either USA or ISO (military time) format
SET HH/MM
MM/DD/YYYY
Sets hour/minutes and month/day/year
DATE On
Off
Select Off to disable the date display if the date and time option is installed. Time
is still displayed.
Brightness (BRIGHT Parameter)
DAY 1-10 Selects the brightness during day. Brightness is set from 1-10 or 10 to 100% of
the
full brightness. IntelliBright averages measured ambient light over a ten
minute time span.
NIGHT 1-5-1
0 Selects the brightness during night. Brightness is set from 1-10 or 10 to 100% of
the full brightness. IntelliBright averages measured ambient light over a ten
minute time span.
Table 3-3. Configuration Menu Summary - Level 3