Specifications
Table Of Contents
- 1.0 Introduction
- 2.0 Mounting Plate Installation and Setup
- 3.0 Configuration
- 3.1 Auto-Learn
- 3.2 Manual Configuration
- 3.3 Serial Communications
- 3.4 Testing the Remote Display
- 3.4.1 Display
- 3.4.2 Digital Outputs
- 3.4.3 Digital Inputs
- 3.4.4 Loop Back
- 3.5 Version
- 3.6 Demand Print Displaying
- 3.7 Serial Commands
- 3.7.1 Command Format (7-Segment):
- 3.7.2 Display Message Command Format (Matrix Display):
- 3.7.3 Set or Get the Digital I/O
- 4.0 Options
- 5.0 Appendix
Configuration 11
The setup button is located on the secondary display board (Figure 3-2).
Figure 3-2. Setup Button Location on Secondary Display Board (7-Segment Display)
The display board is mounted on a hinged mounting plate to allow for easy access to the CPU board. Press the
SETUP button (shown in Figure 3-2) to access main menu configuration parameters.
Main menu parameters include:
• Configuration
• Serial communications
• Test
• Version
The
LaserLight remote display can be configured and displayed using a series of menus accessed using internal
buttons located on the secondary display and shown in Figure 3-3.
Figure 3-3. Configuration Setup Buttons
Use the UP/DOWN, LEFT/RIGHT buttons to navigate through menu items and the ENTER button for setting a
selection.
Jumper position
for decimal point or
comma
Setup button
DOWN
RIGHT
LEFT
UP
SETUP
ENTER