Specifications
Table Of Contents
- 1.0 Introduction
- 2.0 Mounting Plate Installation and Setup
- 3.0 Configuration
- 3.1 Auto-Learn
- 3.2 Manual Configuration
- 3.3 Serial Communications
- 3.4 Testing the Remote Display
- 3.4.1 Display
- 3.4.2 Digital Outputs
- 3.4.3 Digital Inputs
- 3.4.4 Loop Back
- 3.5 Version
- 3.6 Demand Print Displaying
- 3.7 Serial Commands
- 3.7.1 Command Format (7-Segment):
- 3.7.2 Display Message Command Format (Matrix Display):
- 3.7.3 Set or Get the Digital I/O
- 4.0 Options
- 5.0 Appendix
Mounting Plate Installation and Setup 7
NOTES:
•Terminals J6, J8, and J9 are removable screw terminal plugs.
•Port 0 is used for input only and port 1 is used to drive the next
LaserLight Remote Display. See Table 2-2
above.
Connector Pin Assignment Function Port Position
J1 1 Ground
2 Digin 0
3 Digin 1
4 + 5 Volts
5 DigOut 0
6 DigOut 1
7 Ground
J6 1 20 mA Rx+ Port 0
2 20 mA Rx– Port 0
3 20 mA Tx+ Port 1
4 20 mA Tx– Port 1
J8 1 RS-232 TxD 0 Port 0
2 RS-232 TxD 1 Port 1
3 RS-232 RxD 0 Port 0
4 RS-232 RxD 1 Port 1
5 RS-232 SIG GND
6 RS-232 SIG GND
J9 1 RS-485 Rx+ Port 0
2 RS-485 Rx– Port 0
3 RS-485 Tx+ Port 0
4 RS-485 Tx– Port 0
Table 2-2. Serial Communications Wiring