Installation manual

38 IQ9500 Installation Manual
8.13 Z Command
Z command functions are useable when SPEC 14 and SPEC 15 are set as noted in the table below allowing as
function key and are shown below.
Z Command Function Z Command Function
Z0 Rezero Z6 Clear
Z1 Print ZS1 Scale 1
Z2 Unit weight clear ZS2 Scale 2
Z3 Plus ZS3 Scale 3
Z4 Minus ZS4 Scale 4
Z5 Tare -- --
NOTE: SPEC 14, bit 3 (RS-232C Connection) must be set to 1 (Yes) and SPEC 15, bit 2 (RS-232C with Header) must be
set to 0 (Yes) for the console to recognize the Z commands.