Installation manual

34 IQ9500 Installation Manual
Figure 8-4. Sample Epson TM-U200 and TM-U295 Ticket
Output (Not to Scale)
8.4 Epson Ticket Printers
The Epson TM-U295 ticket printer default settings
are 9600 baud rate, eight-bit data length, no parity and
one stop bit and connnected to either the 9-pin D-sub
connector or the 8-pin DIN connector.
NOTE: Epson printers must be connected to the
IQ9500 and powered on before powering up the
IQ9500.
Table 8-8 presents the TM-U295 printer conguration
settings using Specications 3, 10, 11, and 13
connected to the 9-pin D-sub connector. Table 8-9
contains the TM-U295 printer conguration settings
using Specications 3, 10, 11, and 13 connected to the
8-pin DIN connector. Shown in Table 8-10 is the
printer conguration settings using Specications 3,
10, 11, and 13 connected to a 9-pin sub-D connector
while Table 8-11 is the setting for a 8-pin DIN
connector. A sample of the printer printout is shown
in Figure 8-4.
8.5 IQ9500-to-PC Output Data Format
with Header
The IQ9500-to-PC output data format is identied in
SPEC 12, bit 0 and is set to 0. The output data format
includes a header and data. One data consists of
Header, Data and CR. The following illustration
shows the output data format.
NOTES:
CR must be added at the end of the data.
LF must be added at the end as a termination
code of the transmission.
Specication Bit 3 Bit 2 Bit 1 Bit 0
SPEC 3 0001
SPEC 10 1111
SPEC 11 0100
SPEC 13 0000
Table 8-8. Epson TM-U295 (without Form Feed) Printer
Specification Connected to 9-Pin D-Sub Connector
Specication Bit 3 Bit 2 Bit 1 Bit 0
SPEC 3 0001
SPEC 10 1111
SPEC 11 0100
SPEC 13 0001
Table 8-9. Epson TM-U295 (without Form Feed) Printer
Specification Connected to 8-Pin DIN Connector
Specication Bit 3 Bit 2 Bit 1 Bit 0
SPEC 3 0011
SPEC 10 1111
SPEC 11 0100
SPEC 13 0000
Table 8-10. Epson TM-U295 Printer Specification (with
Form Feed) Connected to 9-Pin Sub-D Connector
Specication Bit 3 Bit 2 Bit 1 Bit 0
SPEC 3 0011
SPEC 10 1111
SPEC 11 0100
SPEC 13 0001
Table 8-11. Epson TM-U295 Printer Specification (with
Form Feed) Connected to 8-Pin DIN Connector
Header Data CR Header ........ CR LF