Installation manual

20 IQ9500 Installation Manual
10 0111 RS-232C
Connection (PC/
printer)
0: No
1: Yes
RS-232C (PC/PRN)
Data Length
0: 7 Bits
1: 8 Bits
RS-232C (PC/PRN) Baud Rate
00: 1200 01: 2400
10: 4800 11: 9600
11 0100 RS-232C (PC/PRN)
Stop Bit
0: 1 bit
1: 2 bits
Printer
0: Eltron barcode
printer
1: TMU295/TMU200
RS-232 (PC/PRN) Parity Bit
00: No 01: Odd
10: Not used 11: Even
12 1000 RS-232 (PC/PRN) Output
00: Not available
01: When counting condition (PC)
10: By * key (printer and PC)
11: In both cases
Reserve
Set to 0
RS-232C (PC) with
Header
0: Yes
1: No
13 0000 RS-232 (PC)
Header
0: Code
1: Title
RS-232 Connector
Sub
DIN
If only one RS-232 device (printer/PC) is to be connected to the
scale, then you must select one of the four settings below:
000: Printer (SPEC 10, 11) Force Balance (SPEC 8, 9)
001: Force Balance (SPEC 8, 9) Printer (SPEC 10, 11)
100: PC (SPEC 10, 11) Force Balance (SPEC 8, 9)
101: Force Balance (SPEC 8, 9) PC (SPEC 10, 11)
If two RS-232 devices (printer and PC) are going to be connected to
the scale, then you must select one of the two settings below:
010: Printer (SPEC 10, 11) PC (SPEC 8, 9)
011: PC (SPEC 8, 9) Printer (SPEC 10, 11)
NOTE:
If two peripheral devices are turned on but only one is installed on the scale, an error message will appear on the scale.
14 0111 RS-232C
Connection
(barcode scanner)
0: No
1: Yes
RS-232C (BCS)
Data Length
0: 7 Bits
1: 8 Bits
RS-232C (BCS) Baud Rate
00: 1200 01: 2400
10: 4800 11: 9600
15 0000 RS-232C (BCS)
Stop Bit
0: 1 Bit
1: 2 Bits
RS-232C (BCS)
with Header
0: Yes
1: No
RS-232C (BCS) Parity Bit
00: No 01: Odd
10: Not used 11: Even
NOTE:
Specifications 16 and 17 can only be changed by an authorized service technician!
16* 0001 Scale 1
00: Internal Scale 1
01: Internal Scale 2
10: External scale
11: Force balance
Scale 2
00: Internal Scale 1
01: Internal Scale 2
10: External scale
11: Force balance
Specification Default Bit 3 Bit 2 Bit 1 Bit 0
Table 5-1. Applicable IQ9500 Customer Specifications (141 Settings) (Continued)