User Manual

M-Class 69
5.4.2 Standard Calibration
Standard Calibr ation is appropriate for most media types. During the process, the printh ead assembly can be raised for visual access
to the media and media sen sor. In addition, displayed sensor r eadings can be used to indicate th e best position over the media, whic h
is helpful when using small, position -critical TOF notches or marks. Three readings are required:
Empty: No media in the sensor.
Gap (or Mark): Only the backing, notch , or reflective mark in the
sensor.
Paper: The label (with th e liner attached) in the sen sor.
To perf orm a Standa rd Calibra tion:
Step Operator Action Displayed Message Comment
1
(
Media should be loaded and the
a
pp ropriate Sensor Type sel ected .)
T
urn ‘On’ the printer.
!
!!
VODBMJCSBUFE!
!
Wait until the printer initializ es ( abou t six s econds) .
2
Press the
MENU
Ke y.
Raise t h e pri n thead as sembl y .
!
NFOV!NPEF!
NFEJB!TFUUJOHT!
!!
!
!
You are ent eri ng Menu Mode.
3 Press the
Key to enter the
M edia Settings menu.
!
NFEJB!TFUUJOHT!
NFEJB!UZQF!
!!
!
!
S ee S ection 5.1.2 f or menu layout.
4 Press the
FWD
Key and sc roll
to ‘Sensor Calibration’.
!
NFEJB!TFUUJOHT!
TFOTPS!DBMJCSBUJPO!
!!
!
Press the
Key to a bort this pr ocedure.
5 Press the Ke y.
!
TFOTPS!DBMJCSBUJPO!
QFSGPSN!DBMJCSBUJPO!
!
You are b eginning t he s tanda rd calibra ti on p rocedu re.
6 Press the
Key.
R emove the media from t he
M edia Sens or t hen t he
key.
!!
SFNPWF!MBCFM!TUPDL!
QSFTT!FTD!LFZ!=zzz?!
!
This sets the pa r a meter for the ‘empty’ value.
Wher e ‘ yyy’ is a numeric al va lue rep resenti ng the
cu rrent sensor rea ding.