User Manual

ManualsBrandsRice Lake ManualsScalesDatamax-ONeil M-Class

58 M-Class

Communications (continued)

FEEDBACK CHARACTERS

Returns a Hex 1E, [RS], after each label successfully prints, and a Hex 1F, [US], after each

batch of labels is printed.

ENABLED

Feedback characters are sent to the host.

DISABLED

No feedback characters are sent.

ESC SEQUENCES

Allows data containing invalid ESC control code sequences to be processed, helpful because

some systems send a “banner” to the printer.

ENABLED

Normal printer operating mode.

DISABLED

ESC sequences are ignored and the data is processed. Bitmapped font downloads are disabled in

this mode.

HEAT CO MMAND

Allows the user to disable the DPL Heat Command, providing compatibility with other

DATAMAX printers.

ENABLED

Normal printer operating mode.

DISABLED

DPL Heat commands a re ignored. The heat value is controlled via the menu setting; see Section

5.1.3.

SPEED COMMANDS

Allows the user to disable the DPL speed commands (Print, Feed, Slew, and Reverse).

ENABLED

Normal printer operating mode.

DISABLED

DPL speed commands are ignored. The speeds are controlled via the menu setting; see Section

5.1.3.

TOF SENSING COMMANDS

Allows the user to disable the DPL Top of Form commands (Gap, Continuous, and Reflective).

ENABLED

Normal printer operating mode.

DISABLED

DPL TOF commands are ignored. The TOF is controlled via the menu setting; see Section 5.1.2.

SYMBOL SET COMMAND

Allows the user to disable the DPL Single and Double Symbol Set selection commands.

ENABLED

Normal printer operating mode.

DISABLED

DPL Symbol Set commands are ignored. The Symbol Set selection is controlled via the menu

setting; see Section 5.1.5.

CNTRL- CODES ( DATA)

Al lows th e us er to rem ove cont rol codes (d ata < 2 0 Hex) from t he d ata field s. The s elect ed li ne

terminator is processed.

ENABLED

Normal printer operating mode.

DISABLED

DPL Control Code (SOH, STX, CR, ESC, and ^) functions are ignored.

STX-V SW SETTING S

Allows the user to disable DPL software switch settings commands.

ENABLED

Normal printer operating mode.

DISABLED

DPL option-enable command (<STX>V) is ignored.