User Manual

M-Class 31
Problem Possible Cause Solution
Label Alignment is
incor rect. Press ing
FEED
successively
results in a label length
longer than actual, one-
inch.
Label Alignment Len gth
is not correct. The
default Label Alignment
Len gth is 1.00”, and will
result in th is behavior
wh en an y lar ger label
length is used without
settin g th e appropriate
length
 Set Label Align ment to AUTO. Press and hold
FEED
until
paper moves for automatic Label Align ment length
measurement.
~OR~
 Measure the label len gth an d use the Setup Men u to set the
new length. Print a Database Configuration label to ensure the
new length has been set.
Tear Mode is s elected
but the label stop
position (presen t
position) is not far
enough forward.
Another presen t position
has been determin ed.
Enabling the Presen t
Sens or cau s es the label
stop position (presen t
position) to be
appr oximat ely 0. 1”
beh ind t he peel ba r.
~OR~
The Pres ent A d ju s t va lu e
is not correct.
 Disabl e the Pres ent S ensor .
~OR~
 Ensu re the h ost com pu ter is not p roviding a Present D istance
shorter than is required for the Tear Bar.
 Use th e Setup Men u to modify the Presen t Adjust value.
Tear Mode is s elected
but the label stop
position (presen t
position) is too far
forward.
Another presen t position
has been determin ed.
~OR~
The Pres ent A d ju s t va lu e
is not correct.
 E nsure t he h ost com p ut er i s not p roviding a P resent D istance
longer than is required for the Tear Bar.
 Use th e Setup Men u to modify the Presen t Adjust value.
The
ERROR
light
illuminates during label
alignment.
Th e label supply is empty  Load media.