User Manual

24 M-Class
13) TOF DELTA
Sets the minimum media sensor
change required to signify a la bel
gap or ma rk.
Possible Values:
Range: 0 – 50; n omin a l = *10
(Un its = .1 volt)
14) TOF LOW
Sets the minimum media sensor
reading for paper (gap/notch) or mark
(reflective).
Possible Values:
Range: 0 – 50; n omin a l = *0
(Un its = 0.1 volt)
15) LABEL WI DTH
Sets the label width .
Possible Values:
Range: 75 – 426; default = *426
(Units = .01 inch)
16) S CALABLE FONT
Sets the number of memor y blocks
to allocate for scalable fonts.
Possible Values:
Range: 0 – 128; default = *64
(Un its = 4K Bytes)
17) INTERNAL MO DULE
Sets the number of memor y blocks to
allocate for th e internal RAM module.
Possible Values:
Range: 0 – 128; default = *128
(Un its = 4K Bytes)
18) LABEL ALIGNMENT
Sets the label alignment method (see
Section 4.6)
.
Possible Values:
YES (user manually deter min es
‘ALIGN LENGT H’)
AUTO (printer determin es ‘ALIGN
LENGTH’)
* NO (n o La bel Alignment
used)
19) ALIGN LENGT H
Leading edge distanc e of two su cc e s s ive l abel s.
Must be entered if ‘LABEL ALIGNMENT’ is set
to Yes (see Se ct i on 4. 6).
Possible Values:
0 – 999; default =100*
(Un its = .01 inch)
20) OPTION CONTROL
Sets label stopping (and in certain cases the starting) location for
differ ent prin ter con figurations.
Possible Values:
* AUTO (Automatically sets the stop location. Installed options
will be ‘auto-sen sed’ and the appropr iate stop position
will automatically be set. Host commands are ignored.)
HOST (Sets stop position according to options installed. If n o
option s are installed the printer sets stop location to the
next label’s start of prin t. Host commands will
override.)