User Manual

M-Class 11
5. Close t he Printhead As sembly and press down u ntil it locks into place.
6. Close the cover and press the
FEED
button sever al t imes to position the media and ensu re proper tra cking.
If the p rint er does not c orr ec tly sens e t he top of each label, as denot ed b y the
ERROR
light , it may b e necessar y to:
Printers without f ront display : P erform t he Au to Media Sensor Ca libra ti on, see s ection 4.7.1.
Printers with front di splay : P ress and hold the
FEED
button until at least one label gap or mark is adva nc ed t hen
release. For additional calibra tion procedures, see section 5.4
 Note: The printer i s f act or y set t o use 4-inch media ( and r i bbon, if t hermal t r ansfer equipped). When using a different width of
m edia/ r i bbon, pl ease refer t o section 6. 2.