User Manual
116 M-Class
Configura ti on Using IP Di sc ove r y (DHCP, BootP, and RARP)
Onc e t he E thernet Print Sever has been installed and c onnected, p
lug in the power cord and E thernet cable then t ur n the
printer ’s power swit c h ‘On’.
DH CP , B ootP, and RARP a re server servic es that provide a method f or a ssi gning and maintaining IP addr es ses. The P rint
S erver obtains I P information f rom t his servic e.
The factory default has IP Discovery enabled. The Print Server makes IP requests at power-up. If using this method of
discovery, after the connection is established print a Configuration Label (see below) from the printer to obtain the IP
Addres s and then u se it to install your print er port and dr iver to complete you r set up.
Note: Depending upon y our serv er, y ou may have t o w ait a m inute or t w o for the assigned IP Addres s to appear on
the Conf iguration Label.
To print a configuration label:
With the pr inter on, loaded with media (at
lea st 4 inc hes wide) and r i bb on (if print ing
with therma l transfer media). Press the
b ut ton o n ce, th en us e the
FWD
button scroll to
‘PRINT CO NFI GURATI ON’
and p ress the
button aga in to print.
COMMUNICA TIONS
SER IAL PORT A:
BAUD RATE
9600
PROTOCOL
BOTH
PARI TY
NONE
DATA BITS
8
STO P BITS
1
SER IAL PORT B:
NOT INSTALLED
PARALLEL PORT A:
PO RT DIRECTI ON
UNI-DIRECTIONAL
USB PORT
INSTALLED
NIC ADA PTE R:
MAC:00-0d-70-00-00-09
IP AD DRE SS
168.24.12.192
SU BNET MASK
255.255.255.255
GATEWAY
168.24.254.254
SN MPTRAP DEST INATION
000.000.000.000
IP DISCOVERY
ENABLED
HOST SETTINGS:
HOST TIMEOUT
10 sec
CONTROL CODE S
STANDARD C ODES
FEEDBACK CHARACTERS
DISABLED
PRINT CONTROL
HEAT
10
PRINT SPEED
8.0 in/sec
F E ED SPEED
8.0 in/sec
REVERSE SPEED
4.0 in/sec
ROW OFFSET
00.00 inches
COLUM N O FFSET
00.00 inches
PRESENT DISTANCE
0.00 inches
CU STOM ADJ US TMEN TS:
DARKNESS
32
CONTRAST
32
ROW ADJ UST
0 DOTS
COLUMN ADJ US T
0 DOTS
PRESEN T ADJ UST
64 DOTS
PRINTER OPTIONS
MODULES
A: NOT INSTALL ED
B: NOT INSTALL ED
D: NO T INS TAL L ED
F: NOT INSTALLED
G: NOT INSTALLED
X: NOT INSTALL ED
Y: NOT INSTALLED
Z: NOT INSTALLED
PRESENT SENSOR:
MODE
DISA BLED
RETRACT DELAY
0 X 10mS
As si gned IP
Address
Onc e you have obt ained the a ssi gned IP from t he conf igura tion label you c an then ins ta ll the p ort and print er driver using
t he W indows
®
‘Add a P rinter Wizard’. See section, Installing the Printer Driver and Port in this doc u ment.