User guide

Chapter 4 – Menu System 31
DELETE FILE * Selects from the list of available files for deleting. (See File Handling Messages.)
COPY FILE * Selects from the list of available files for copying, prompting you for the
destination module before execution. (See File Handling Messages.)
UNPROTECT
MODULE *
Selects from the list of available modules to unprotect, and then prompting you
regarding the outcome of the attempt. (See File Handling Messages.)
PRESENT SENSOR Controls the "on-demand" dispensing of labels , where:
MODE Sets the detection method and response of the printer:
AUTO Is the default setting. Automatically detects, enables the Present Sensor (or Peel
and Present mechanism) and sets the label stop location; if not detected, the
operation will be ignored.
ENABLED Enables the Present Sensor (or Peel and Present mechanism) and sets the label
stop location; if not detected, a fault will be generated.
DISABLED Disables the option.
RETRACT DELAY
*
Programs a time delay for the retraction of the next label in the print process,
where:
(1 - 255 x 10
mS)
070
Is the range, times 10 milliseconds; and,
Seventy (times ten) is the default setting.
CUTTER Controls the Cutter operation, where:
MODE Sets the detection method and response of the printer:
AUTO Is the default setting, where the presence of the cutter option is automatically
sensed. If detected, the cutter is enabled; otherwise, it will be ignored.
ENABLED Enables the cutter. If the cutter is not detected, a fault will be generated.
DISABLED Disables the cutter.
CUT BEHIND Allows a number of small labels to queue before a cut is performed to increase
throughput.
;
(1) This mode can be used without a cutter to allow the presentation of
an extra label with retraction upon the next job or feed operation.
(2) After a fault or unknown label position, the leading edge will be cut
to ensure no extra material exists at the beginning of the first label;
otherwise, the cutter will only cut when necessary.
(0 – 2)
0
Zero, one, or two are the number of labels to queue before cutting; and
Is the default setting.
RFID Controls the programming and verification of RFID tags, where:
;
If not installed (or detected), this selection will result in a DISABLED
message.
RFID MODULE Sets the mode of RFID operation, where:
DISABLED Disables the option.
HF Selects the High Frequency (13.56 MHz) RFID option.
UHF MULTI-
PROTOCOL
Selects the Ultra High Frequency (868-956 MHz) RFID option.
RFID POSITION* Sets the RFID inlay location.
(1.10 - 4.00 IN.)
1.10
This location is referenced from the leading edge of the label or tag, as it moves
forward through the printer.
Is the default setting.
HF SETTINGS * Sets HF tag parameters, as follows:
TAG TYPE Sets the tag type:
ISO 15693 (Is the default setting.)
TI
PHILIPS
ST LRI512
ST LRI64
AFI VALUE Application Family Identifier value (00 - FF), where 00 is the default value.
AFI LOCK Application Family Identifier lock (ENABLED / DISABLED), where DISABLED is the
default setting.