Installation and Operation Manual Instruction Manual

8.0 Display Messages

The following table shows the messages that are displayed during operation of the IQ6200/6500.

Message Description

—Add XX Sample size is too small

All CLEAr Clearing all items in memory

C XX Number of items in memory

CH XX Checking part code

CLEAr Clearing one item in memory

dA - XX - XX - XX (IQ6500 only) Setting date and time

(printer) Comm on (IQ6500 only) (printer) Printer on

(printer) Comm off (IQ6500 only) (printer) Printer off

Err - (IQ6500 only) Error during data transfer

InSUFS Setting insufficient sample size

InVEnt CLEAr Clearing inventory data

Lo-Err Zero is out of range on the low side

L-YEAr (IQ6500 only) Setting Leap Year constant

P-no CLEAr Clearing part number

P-oFF (IQ6200 only) Setting “sleep” time for battery option

ProG. In programming mode

SEt 1 Setting setpoint 1

SEt 2 Setting setpoint 2

SPEC XX Setting Spec Data

t-C XX XX (IQ6500 only) Programming alpha/numeric part number

tArE CLEAr Clearing tare weight in memory

totAL XXXX Doing “+” “–” accumulating operation

through - C XX XX (IQ6500 only) Programming alpha/numeric part number

UnIt CLEAr Clearing unit weight in memory

UP-Err Zero is out of range on the high side

UEr - XXXX Software version number (only appears after scale is plugged into AC

power and turned on)