Installation and Operation Manual Instruction Manual

3.2.2 IQ6500 Indicator Lamps

Use the following table to identify display indicator lamps that may be illuminated during operation.

Lamp Function

ZERO Scale is within 1/4 division of true zero

TARE Presence of a tare weight

GROSS Gross weight is shown

INSUFF Sample size is too small

RECOMP Unit weight may be recalculated when lit by pressing the PIECES key

MEMORY An accumulated total is in memory

OUT Quantities being removed from inventory total

IN Quantities being added to inventory total

SCALE2 Scale 2 in use

PROG Scale is in program mode

kg Scale weighing in kg

lb Scale weighing in lb

3.3 Initial Performance Testing

Use the procedures in this section to test your IQ6200/6500 keypad and display prior to its initial use. The

procedures verify proper operation of the scale’s keypad and displays. Tests are available for the following

functions:

• Key Entry of Unit Weight

• One-Touch Tare

• Digital Tare Entry

• Weight, Unit Weight, and Quantity Displays

• Accumulation

• User-Determined Sample

3.3.1 Unit Weight Display and Unit Weight Key Entry

1. Press 0, then UNIT WEIGHT to clear any unit weight.

2. Press 1 five times, then UNIT WEIGHT once. The Unit Weight display now shows 11111.

3. Press 0, then UNIT WEIGHT to clear the display.

4. Repeat for each number (2, 3....0).

5. Check decimal entry by entering 12.34, then press UNIT WEIGHT.

3.3.2 One-Touch Tare

1. Press 0, then TARE to reset any tare.

2. Press REZERO to re-zero scale.

3. Place empty container on scale, then press TARE once. The Weight display should now show zero

with empty container on scale.

4. Remove container. With nothing on the scale, press TARE to reset tare to zero.

PART #

– / PART#

Used to subtract parts from an accumulation operation or view an alternate part number.

DATE

+ / DATE

Used to add parts from an accumulation operation or set the date and time in the program

mode.