User Manual - Version 2.1 Owner manual

Counterpart User Manual - Serial Commands 69
6.1.6 Normal Mode Commands
The normal mode print commands (see Table 6-12) transmit data to the serial port on demand in either setup or
normal mode.
6.1.7 Unique Commands
ETH.DNSPRIMARY DNS Primary 0.0.0.0
ETH.DNSSECONDARY DNS Secondary 0.0.0.0
ETH.IPADDRESS IP Address 192.168.0.1
ETH.LOCALHOSTNAME Local Host Name COUNTERPART
ETH.MACADDRESS Mac Address 00-00-00-00-00-00
ETH.NETMASK Netmask 0.0.0.0
ETH.PORT Port 10001
ETH.REMOTESERVERIP Remote server IP 0.0.0.0
ETH.REMOTESERVERPORT Remote server port 5466
ETH.WEIGHVAULT WeighVault OFF, ONBOARD, EXTERNAL
ETH.ECHO Echo EDP commands ON, OFF
Command Description Values
CONSNUM#n Set consecutive number 0–9 999 999
UID#n Set unit ID nnnnnnn
SD#n Set date MMDDYY, DD
MMYY, YYMMDD, or YYDDMM. Enter six-digit date using the
year-month-day order specified for the DATEFMT parameter, using only the last
two digits of the year.
ST#n Set time hhmm (ent
er using 24-hour format)
SX#n Start serial port streaming OK or ??
An EX command sent while in menu mod
e does not take effect until the
indicator is returned to normal mode.
The EDP.Stream must be set to LFT or INDUST for this command to work.
EX#n Stop serial port streaming
XG#n Transmit gross weight in displa
yed units nnnnnn UU
where nnnnnn is the weight value, UU is the units.
NOTE: Y
ou can also send XGP, XGS, XGT, XTP, etc. to specify primary,
secondary or tertiary (P.S.T.).
XN#n Transmit net weight in displayed units
XT#n Transmit tare weight in displayed units
XA#n Transmit accumulator value
RS Reset system Soft reset. Used to reset the indicator without r
esetting the configuration to the
factory defaults.
KSOFT1-4 Command to perform function assigned
to softkey
.
n/a
Table 6-12. Normal Mode Serial Commands
Command Description
DUMPID.INDEX=n To dump an ID by register
DUMPID.CODE=n To dump an ID by code
KDISPMODE Set or request the current display mode. KDISP=COUNT. W
ill switch to that mode. This only temporariliy
switches display. Default is set by dispmode parameter.
Other choices include:
COUNT
WEIGHT
UNIT WEIGHT
Table 6-13. Unique Commands
Command Description Values
Table 6-11. Ethernet Serial Commands