User Manual - Version 1.0 Owner's manual

Counterpart User Manual - Configuration 37

3.9 Display Menu

There are three display settings on the Counterpart.

Figure 3-13. DISPLAY Menu

Setting the display parameters from this top level menu is temporary - after a power cycle, the values will revert

to their previous values. Changes made to these parameters through the CONFIG menu are kept through a power

cycle.

LOOP TEST Performs a loop test on dig I/O cards.

DIO 1

DIO 2

DIO 3

DIO 4

STATUS Displays the status of each individual digital I/O port. If set as input, the display

shows input stats IN HI or IN LO. If set as output, pressing Enter toggles the

output between HI and LO. OUT HI or OUT LO.



OUT LO is active.

PORT1

PORT2

TEST Performs a loopback test on serial port 1 or 2. Connect jumper TX and RX

together on port 1 or port 2 before testing.

TEST Menu

Parameter Choices Description

Table 3-11. TEST Menu Parameters

CONTRAST

XXXXXXX

ID DISPLAYTESTSETUPAUDIT CALIBR

BRIGHT IMAGE

100

0-100%

Negative

Positive