User Manual Rev. E - Version 2.5 User guide

Serial Commands 73
6.1.2 ID Commands
Up to 150 codes can be entered under ID commands.
Table 6-2. ID Commands
Command Function
ID.CODE#n ID code
ID.DESC#n Item description
ID.LOCATION#n Item stock location
ID.LOT#n Lot number
ID.PARTNUMBER#n Part number
ID.QUANTITY#n Inventory quantity
ID.TARE#n Tare weight value
ID.UNITS#n Units for tare and unit weight values
ID.UNITWEIGHT#n Unit weight value
ID.CLRALL Clear all IDs from memory
Note: The ID.CLRALL command only works in setup mode
ID.CLEAR.INDEX#n Clear ID at index n from memory
ID.CLEAR.CODE#n Clear ID with code of n from memory
6.1.3 Reporting Commands
Reporting commands send specific information to the serial port. The commands listed in Table 6-3 can be used in
all modes.
Table 6-3. Reporting Commands
Command Function
DUMPALL List all parameter values, ID information and setpoint data
DUMPCONFIG List all parameter values excluding ID information and setpoin
t data
DUMPAUDIT List audit trail information
DUMPBUFFER Lists Weighvault buffer information
DUMPIDS List all ID information
DUMPID.INDEX List a specific ID by index. See Section 6.1.7 on page 78 for more information.
DUMPIDCODE List a specific ID by code. See Section 6.1.7 on page 78 for more information.
VERSION
Write
Counterpart software version
P Write current displayed weight with units iden
tifier. See Section 9.2.1 on page 90.
XE Returns a 10-digit code representing any error c
onditions currently shown on the front panel.
ADCS Return number of A/Ds installed
Note
Transmit all configuration settings with the DUMPALL command.
KENTER Press the ENTER key.
KLOCK Lock specified front panel key. For example, to lock the ZERO key, enter KLOCK = KZERO.
KUNLOCK Unlock specified front panel key. For example, to unlock
the PRINT
key, enter KUNLOCK = KPRINT.
KDATE Display date (pseudo key).
KTIME Display time (pseudo key).
KESCAPE Exits the selected parameter. Returns to weigh mode if a parameter is
not selected (fun
ctions identical to the
MENU key in menu mode).
KSOFTx Press softkey number x
Command Function
Table 6-1. Serial Key Press Commands