User Manual Rev. E - Version 2.5 User guide

6 Counterpart Counting Scale Indicator
Set Date and Time
1. If the softkey is enabled, push the softkey. The current value is displayed.
2. To change, use the Up/Down arrows to highlight the val
ue to change.
3. Press the
TARE key to save and exit.
Set Serial Scale (Scale 3)
1. Select Port 1 — Indust Scale.
2. Match the baud rates. Upon doing this it automati
cally becomes Scale 3.
Setting up a Softkey
To set up a softkey, use the following steps:
1. Press the
MENU SETUP
MENU
SETUP
key.
2. Navigate through the menu setup to Setup using the
key.
3. Press
to navigate to CONFIG.
4. Press
to navigate to SCALES.
5. Press to navigate to FEATURE.
6. Press to navigate to COUNT.
7. Using scroll through until you get to SOFTKEYS.
8. Scroll down. Then using
scroll through menu selections SK1 through SK12.
9. Press
to assign a softkey to that position.
10. Select a choice that you wish to be displayed.
11. Press
once the function is selected.
12. Press
Save/Exit softkey.