User manual

On/Live Mode:
When the Power switch is moved to ON, the Spydercam will be in the Live mode. At
this stage the motion indicator LED on the front will blink green for about 15 seconds. In
this mode the settings, as per ADVANCED OPERATIONS below, will be activated.
Powering Off:
To switch the Spydercam off, slide the switch to the OFF position. Please note that even
while the device is switched off, it will still consume power at the UA level. It is
therefore advisable to remove the batteries from the battery depot if the device is not
going to be used for an extended period.
Advanced Operations
Now that you have familiarized yourself with the basic functionalities of the Spydercam,
it is strongly advised that you please read the advanced operation instructions below to
optimize the benefits you can get from the use of your new Spydercam.
Category Settings
In order for you to change the category settings on the Spydercam, you are required to
switch it into the Test mode. For your convenience it is also possible to set categories
while the Spydercam is linked to the TV output if you find the LCD screen to be too
small.