User manual

Spydercam stops taking images
 First ensure that the SD Card has memory available. If the card is full, the Spydercam
will stop taking pictures and shut down automatically.
 Check the batteries (as per above).
 Ensure the Spydercam is in the ON Mode and not in the OFF or TEST modes.
The Spydercam cannot switch on
 Ensure that you have installed the batteries in accordance to the indications in the
battery depot.
 If you are using an external adaptor, ensure it is switched on.
Photograph and/or Video Quality Issues:
Nigh time Photos/Videos appear too dark:
 Check if the battery power is full. The flash will stop operating towards the end of the
battery life.
 You will achieve the best results if the subject is within the ideal flash range.
Anything beyond 12m (outside the 62º angle) will appear dark.
 If the Spydercam is set to take more than one image (Capture Number), the latter
images might be darker because of the time it takes for the flash to fully recharge.
 As per above the latter images might be darker if the interval (Interval Setting)
between images are too short.
Day time Photos/Videos appear too dark:
 Ensure that the Spydercam is not aimed directly into the sun or other light sources,
since it may cause the auto exposure to produce darker images.
Nigh time Photos/Videos appear too light:
 You will achieve the best results if the subject is within the ideal flash range.
Anything closer than 3m (inside the 10º angle) will appear too light.
 Ensure that you have not set the Spydercam up in such a way that light will reflect
back from a painted wall.
Day time Photos/Videos appear too light:
 Ensure that the Spydercam is not aimed directly into the sun or other light sources,
since it may cause the auto exposure to produce bright images.
 If the IR LED is used, images within a 2 meter area will be too bright.