Installation guide

11
Networking
• Right click to open the menu and select “MAIN MENU”.
• Select “SETTING”
• Select “NETWORK”
The device comes pre-configured to DHCP. If not, you need only to check the DHCP box and click
save, settings will be allocated automatically.
If this does not suit your needs, see the example below.
Choose “Static” to allocate an IP address manually, and then enter the IP Address, Subnet mask, and
Gateway.
For Example we have used:
Should you wish to set your DVR up for internet access, you will require:
• An ADSL connection of 512/512 minimum (ADSL2 recommended).
• Ideally, an External Static IP address from your Internet Service Provider, if not applicable, seek out
a Dynamic DNS Service and follow their instructions.
• An ADSL Modem which supports Port Forwarding.
• A network connection between your NVR and the ADSL Modem.
• Set your DVR up on the local network by giving it a compatible IP Address.
• In your modem Port Forward port 88 to the IP address of your DVR.
Important:
Before setting up remote access for your NVR, you will need to have a good understanding of
computer networking. Otherwise please seek the assistance of a qualified I.T. person.