Installation guide

9
System Structure C – Standalone 1 to 1 system via an existing computer network
This configuration is very similar to B as it requires a Cat5e network cable from both the Indoor Monitor
and Door Station, to your network switches and then uses the existing LAN to connect. Even through the
Intercom system will be running across your network, it will still use its own IP addresses of 10.22.5.180
(Indoor Monitor) and 10.22.5.189 (Door Station).
You have the option of using the default IP address range 10.22.5.x (and not changing anything) or using
your own LAN IP address range (and changing the IP Address of each units). So in this example we will
be using the default IP address range 10.22.5.x and leaving it as is.
- Advanced System Structure
- Plug and Play, no set up required.
- Uses a default IP Address range.
- Each Indoor Monitor and Door Station will require their own 12vDC power supply.
- Network switch required.
1. Install each unit at their respective location and connect to their Cat5e network cable.
2. Connect each Cat5e network cable to the network switch.
3. Power on the Door Station
4. Power on the Indoor Monitor
5. You have now successfully set up your VIPvision Intercom System.