Installation guide

8
System Structure B – Standalone 1 to 1 system via a network switch
This configuration requires a Cat5e network cable from each Indoor Monitor and Door Station, to the
network switch.
- Simple System Structure
- Plug and Play, no set up required.
- Uses a default IP Address range.
- Each Indoor Monitor and Door Station will require their own 12vDC power supply.
- Network switch required.
1. Install each unit at their respective location and connect to their Cat5e network cable.
2. Connect each Cat5e network cable to the network switch.
3. Power on the network Switch
4. Power on the Door Station
5. Power on the Indoor Monitor
6. You have now successfully set up your VIPvision Intercom System.