Installation guide

4
Installation of an Indoor monitor
1. Use screw b to fix bracket ② onto box ④.
2. Use screw a to fix bracket ② onto wall ③.
3. Connect network cable and 12vDC power
4. Face rear installation slot to slot on bracket. Make it against wall and push lightly downward until it
fits in to slot on bracket.
5. Remove: Insert small screwdriver into hole on device ①, and push device upward until removed.
Screw Illustration
No.
Name
Illustration
Quantity
a
ST3×18 Cross recessed pan head tapping screws - white alloy
3
b
M4×30 Cross recessed pan head screws
2
c
Expansion pipe ￠6*30mm white
3