Installation guide

How to connect to an IP Camera from the Indoor Monitor

In order to connect to an IP Camera from the Indoor Monitor, both the Intercom system and the IP

camera will need to be connected to the same computer network and use the same IP Address range.

If using a NVR system with a built in (Plug & Play) POE switch, the intercom will not be able to connect

to the individual IP Cameras. You will need to change the IP Camera over to the local network with local

IP Addresses. Please see your NVR User Guide to do this.

1. To add the IP Camera in to the Indoor Monitor, Go to Settings > IPC Info

2. Enter a Name, IP Address and the Default factory user name of admin and password of admin.

The Indoor Monitor can only connect to the IP Cameras Extra Stream when set to D1 resolution. This is

thanks to the monitor itself only being capable of displaying a D1 image. In order to configure the IP

cameras Extra Stream you will first need to log in to its web interface. To do this:

1. Type the IP Cameras IP Address in to Internet Explorer (providing you have already found its IP

address). e.g. http://10.1.1.108

2. Go to SETUP > CAMERA > VIDEO and make sure you set the Extra Stream resolution to

D1(704*576). The Watermark can also be turned off.