Installation guide

20
Set the Time and Date
When using your Intercom system you may need to set the correct Time and Date.
The Indoor Monitor takes its Time and Date from the Door Station itself. Should you also have an NVR
connecting to your Door Stations, then the Door Stations will take their Time and Date from the NVR.
When using an NVR with your Intercom System:
1. Go to your NVR that is displaying the Door Stations Cameras.
2. Right clicking anywhere on the screen will bring up the password menu.
3. Use the mouse to enter the NVR admin password with the on-screen keypad.
4. Then Right click to open the menu and select “MAIN MENU”.
5. Select “SETTING”
6. Select “GENERAL”
7. Set System Time, Date Format and DST (Daylight Saving Time) for your region.
If you do not have an NVR:
1. You will need to have a PC (in the same IP range) that is capable of connecting to the Web Interface
of the Door Station.
2. Open Internet Explorer and input the Door Station IP Address in to the IE address bar.
e.g. http://10.22.5.189
3. Log in with the Default username name of admin and password is also admin.
4. You will then be able to go to System Config > Local Config > System Time. Here you can change
the Time and Date format and Sync the Door Station to your PC time.