Installation guide

16
19. Go to LOGOUT > REBOOT DEVICE and click to REBOOT DEVICE. The Door Station will
now restart with the new configuration. Please allow up to 5 minutes for this to happen.
20. ----- Repeat Steps 13–19 for any additional Door Stations -----
21. Now that all Door Stations are set up, we can go back to the Master Indoor Monitor
22. On the Indoor Monitor go to SETTINGS > PROJECT SETTINGS > then enter password
002236
23. Choose NETWORK and you will see the settings for the Primary Door Station. Here you can
change the name of the device, change the IP Address to that of your first Door Station
10.1.1.189 and ensure its Enable Status is set to ON. e.g.
Name: Main VTO
Device: Unit Door Station
IP: 10.1.1.189
Enable Status: ON
24. Press the Next Arrow “ > ” and you will see the settings for the additional Door Stations. Enter
a name for your secondary door station, the IP Address and set Enable Status to ON. e.g.
Name: Sub VTO
Device: Unit Door Station
IP: 10.1.1.190
Enable Status: ON
----- Repeat Step 24 for each Door Station -----
25. You have now successfully set up your VIPvision Intercom System.
Device:
IP Addresses (used in our example):
Master Indoor Monitor 102
10.1.1.180
Extension Indoor Monitor 102-1
10.1.1.179
Extension Indoor Monitor 102-2
10.1.1.178
Extension Indoor Monitor 102-3
10.1.1.176
Extension Indoor Monitor 102-4
10.1.1.175
Extension Indoor Monitor 102-5
10.1.1.174
Door Station 1
10.1.1.189
Door Station 2
10.1.1.190
Door Station 3
10.1.1.191
Door Station 4
10.1.1.192
Door Station 5
10.1.1.193
Door Station 6
10.1.1.194