Installation guide

13
8. Power on the Extension Indoor Monitor.
9. On the Extension Indoor Monitor go to SETTINGS > PROJECT SETTINGS > then enter the
password 002236
12. Choose NET INFO and change the IP address of this Indoor Monitor from 10.22.5.180 to
10.22.5.179 and press ok to save. (see “How to change the Indoor Monitor IP Address”).
10. Choose PROJECT INFO and set mode to Extension. You can now set the Room number to the
same as the Master but add “ -1 “ to show that it is the first extension (such as 102-1). Finally you
will have to enter the IP address of the Master Indoor Monitor 10.22.5.180 and press ok to save.
(see “How to set up an Indoor Monitor as an Extension Monitor”).
11. Using a PC, log in to the web interface of the Door Station IP Address. The default address for a
Door Station will be 10.22.5.189, and your PC will need to be set to an IP address that is in the
same network range as the camera. We recommend setting your PC to 10.22.5.100
12. Open Internet Explorer and type http://10.22.5.189 in the IE address bar.
13. Log in with the Default factory name of admin and password is also admin.
14. Go to SYSTEM CONFIG > INDOOR STATION MANAGER. Delete any default room numbers
such as 9901 then click on “Add” to add a new Room No. Leave the name and IP Address blank
and simply enter the “VTH Short No” which will be the Room No. of your Master Indoor Monitor.
(such as 102). Then click Ok to save.
15. Go to SYSTEM CONFIG > LAN CONFIG. Tick the Checkbox to enable “Group Call”, and then
click Ok to save.
16. Go to LOGOUT > REBOOT DEVICE and click to REBOOT DEVICE. The Door Station will now
restart with the new configuration. Please allow up to 5 minutes for this to happen.
17. You have now successfully set up your VIPvision Intercom System.