Installation guide

10
System Structure D – Multiple Door Stations to a Monitor via a network
This configuration is more complex as you will need to change the IP address of the Door Stations. You
will require a Cat5e network cable from each the Indoor Monitor and Door Station, to a network switch or
to your existing LAN.
You have the option of using the default IP address range 10.22.5.x (and only changing the IP Address
of 1x Door Station) or using your own LAN IP address range (and changing the IP Address of all 3 units).
However in this example we will be using the default IP address range 10.22.5.x and only changing the
IP address of the first Door Station.
- More Complex System Structure
- Some IP Set Up Required.
- Uses a default IP Address range.
- Each Indoor Monitor and Door Station will require their own 12vDC power supply.
- Network switch required.
1. Install each unit at their respective location and connect to Cat5e network cable.
2. Connect each Cat5e network cable to the network switch.
3. Power on the network Switch if not already on.
4. Power on the Secondary Door Station First
5. Using a PC, find and change the Door Station IP Address from 10.22.5.189 to 10.22.5.190
(see “How to change the Door Station IP Address”).
6. Power on the Primary Door Station (which will keeps its default address 10.22.5.189)
7. Power on the Indoor Monitor
8. On the Indoor Monitor go to SETTINGS > PROJECT SETTINGS > then enter password 002236