Specifications

R2T1 and R4T1 E1 Configuration:
insmod /lib/modules/`uname -r`/extra/rxt1.ko t1e1override=15
(if this does not work try: insmod /lib/modules/`uname -r`/extra/rxt1.ko e1=15)
Load Identifier (Module Instance Load order)
Normally Linux loads PCI devices in the order that they are found on the PCI bus, most likely from the PCI
slot closest to the CPU on the motherboard, and outward from that position. For a digital telephony card,
slot 1 would become the first span loaded, and would default to Span 1 in all configurations. The Load
rotary switch allows for alternate loading of the position of the PCI card, and allows for spans to be loaded
in a different order than how the cards are located in the motherboard.
3.c Generic Instructions for Installing ALL Rhino PCI cards. OS and Zaptel agnostic.
Note: TRIXBOX 2.2 users. Please follow the directions at the end of the installation section.
Note: The Rhino drivers (module) are only compatible with the Linux kernel 2.6.9 and higher. Please
make sure this is installed and the Rhino OST PCI card is properly installed before continuing with the
software configuration.
1. Boot the PC and log in as “root” or other user that has appropriate software build privileges.
2. Navigate to the Zaptel source directory. This is normally located in:
“/usr/src/zaptel”. If the Zaptel source is not present, you will need to download that using the
next sections. If the Zaptel directory is already present, you may jump to number 10 below.
Note: The zaptel source directory can be anywhere on your hard drive, you will need to locate where you
installed zaptel if the above example does not work for you. However if the zaptel directory is anything
other than “/usr/src/zaptel” then create a link that points to the actual Zaptel source directory.
Zaptel Source Installation Notes (only if needed, these optional steps are shown with a >x below, items 3
through 9 below):
Note: For Trixbox 2.x users the Zaptel source and kernel-headers must be downloaded. If you are using
Trixbox 2.x you need to download the Zaptel source, and recompile Zaptel. In the “/usr/src” directory (cd
/usr/src) please install zaptel:
>3. Download the Zaptel source, making sure that you are in the /usr/src directory:
wget ftp.digium.com/pub/telephony/zaptel/releases/zaptel-version.number.tar.gz
>4. Decompress the downloaded tarball
tar -xzvf zaptel-version.number.tar.gz
>5. Create a symbolic link to zaptel:
Rhino Equipment Corp. • 8240 S. Kyrene Rd. • Suite 107 • Tempe, AZ 85284 • [phone]
16