User guide

the same information provided for the Digium TDM400P but select Analog-
A40000D rather than Analog-TDM400P. Otherwise the settings are the similar.
Digital T-1 Lines with PCI Cards
Evolution supports digital T-1 telephone lines using PCI cards. Each PCI card has a
specific pre-configuration process to install the drivers for the card but afterwards
configuration of each card type is similar.
Digital PCI Cards
Card
Description
T1/PRI-A101D
Sangoma A101D PCI card for 1 T-1 digital port.
T1/PRI-A102D
Sangoma A102D PCI card for up to 2 T-1 digital ports.
T1/PRI-A104D
Sangoma A104D PCI card for up to 4 T-1 digital ports.
T1/PRI-R1T1
Rhino R1T1 PCI card for 1 T-1 digital port.
T1/PRI-R2T1
Rhino R2T1 PCI card for up to 2 T-1 digital ports.
T1/PRI-R4T1
Rhino R4T1 PCI card for up to 4 T-1 digital ports.
T1/PRI-TE110P
Digium TE110P PCI card for 1 T-1 digital port.
T1/PRI-TE120P
Digium TE120P PCI card for 1 T-1 digital port.
T1/PRI-TE220P
Digium TE220P PCI card for up to 2 T-1 digital ports.
T1/PRI-TE410P
Digium TE410P PCI card for up to 4 T-1 digital ports.
T1/PRI-TE420P
Digium TE420P PCI card for up to 4 T-1 digital ports.
PCI card physical installation
Follow these steps if your PCI card is not already physically installed in your
Evolution server.
1. With the Evolution server powered down and the power cable disconnected,
open the server’s case and insert the PCI card into one of the available PCI
slots. Refer to the card’s manufacturer for additional installation and system
requirements: http://www.digium.com, http://www.rhinoequipment.com, http://
www.sangoma.com.
2. Close the server’s case and reconnect the power cable.
3. Boot the server.
4. Follow the specific steps for your card below.
Digium TE110P
The Digium TE110P is an internal PCI card that offers one T-1
digital interface. It is compatible with standard service provider T-1
technologies that use either in band or out of band signaling.
Examples include basic T-1s, line-side or trunk-side T-1s and ISDN
Primary Rate Interface T-1s (PRI). Follow these steps to configure
the TE110P:
1. Follow the steps above in the section “PCI card physical installation” if your
PCI card is not already physically installed in your Evolution server.
2. Log in to the Evolution web interface.
3. Click on the Resources tab and then click on the Phone Lines menu item.
4. At the bottom of the screen is a drop-down menu titled Setup New Phone
Lines. Select T1/PRI-TE110P.
28