User guide
Analog Trunks with Digium TDM2400P
The Digium TDM2400P offers up to 24 analog ports. It has six slots for daughter
modules. Each daughter module provides four analog ports. Start with slot six
(FXO port 24) and work down if you are installing fewer than 24 analog ports. For
example, if you have twelve FXO ports using three daughter modules the modules
should be in slots 4 through six and you should use ports 12 through 24.
The TDM2400P is a full length PCI card so ensure that your server chassis has the
space to accommodate it. The card uses a RJ-21 connector (often referred to as an
Amphinol connector). This is a 25-pair telco connector that must be connected to a
break-out panel or a punch-down block. Send an email to
pbxsales@intuitivevoice.com to purchase a cable and breakout box.
Configuration of the 2400P is similar to the TDM400P. Follow the steps above in
the section “PCI card physical installation” if your PCI card is not already
physically installed in your Evolution server. Log in to the web interface and
configure the card using the same information provided for the Digium TDM400P
but select Analog-TDM2400P rather than Analog-TDM400P. Otherwise the
settings are the similar.
PIKA InlineMM
The PIKA InlineMM includes four analog ports with echo cancelation. Follow the
steps above in the section “PCI card physical installation” if your PCI card is not
already physically installed in your Evolution server. At the Evolution server
terminal screen type installpika to install the PIKA drivers (note that there
are no spaces). The server will automatically install the drivers and reboot the
system. Once it is rebooted log in to the web interface and configure the card using
the same information provided for the Digium TDM400P but select Analog-
PIKA rather than Analog-TDM400P. Otherwise the settings are the similar.
Rhino R4FXO
The Rhino R4FXO card includes four analog ports. Follow the steps above in the
section “PCI card physical installation” if your PCI card is not already physically
installed in your Evolution server. At the Evolution server terminal screen type
installrhino to install the Rhino drivers (note that there are no spaces). The
server will automatically install the drivers and reboot the system. Once it is
rebooted log in to the web interface and configure the card using the same
information provided for the Digium TDM400P but select Analog-R4FXO rather
than Analog-TDM400P. Otherwise the settings are the similar.
Sangoma A200D
The Sangoma A200D card is modular and can accept up to 24 analog ports. Follow
the steps above in the section “PCI card physical installation” if your PCI card is
not already physically installed in your Evolution server. At the Evolution server
terminal screen type installsangoma to install the Sangoma drivers (note that
there are no spaces). The server will automatically install the drivers and reboot the
system. Once it is rebooted log in to the web interface and configure the card using
the same information provided for the Digium TDM400P but select Analog-
A200D rather than Analog-TDM400P. Otherwise the settings are the similar.
Sangoma A400D
The Sangoma A400D card is modular and can accept up to 24 analog ports. Follow
the steps above in the section “PCI card physical installation” if your PCI card is
not already physically installed in your Evolution server. At the Evolution server
terminal screen type installsangoma to install the Sangoma drivers (note that
there are no spaces). The server will automatically install the drivers and reboot the
system. Once it is rebooted log in to the web interface and configure the card using
27