User guide

options that you can choose from in this field change according to the type
of destination that you select in the Send Calls To field. For example, if you
choose Extensions then Evolution will provide all of the extensions that
you have configured as options in the Location field. Also note that you
must configure your extension, extension group, auto attendant, or custom
routing rule before you can select it as an option in the Location field.
5. Click the Save button.
Analog Lines with PCI Cards
Evolution supports analog telephone lines using PCI cards. Each PCI card has a
specific pre-configuration process to install the drivers for the card but afterwards
configuration of each card type is similar. Evolution supports FXO ports and not
FXS ports using PCI cards.
Analog PCI Cards
Card
Hardware Echo?
Description
Analog-PIKA
Yes
PIKA Inline MM PCI card for up to 4 analog ports.
Analog-A200D
Yes
Sangoma A200D PCI card for up to 24 analog ports.
Analog-A40000D
Yes
Sangoma A400D PCI card for up to 48 analog ports.
Analog-R4FXO
Optional
Rhino R4FXO PCI card for up to 4 analog ports.
Analog-TDM400P
No
Digium TDM400P PCI card for up to 4 analog ports.
Analog-TDM2400P
Yes
Digium TDM2400P PCI card for up to 24 analog ports.
PCI card physical installation
Follow these steps if your PCI card is not already physically
installed in your Evolution server.
Note: The Evolution web interface does not support FXS modules
on PCI cards. Please use external Analog Terminal Adapters such as
the Linksys PAP2T-NA for easy FXS support.
1. With the Evolution server powered down and the power cable
disconnected, open the server’s case and insert the PCI card into one of the
available PCI slots. Refer to the card’s manufacturer for additional installation
and system requirements: http://www.digium.com, http://
www.pikatechnologies.com, http://www.rhinoequipment.com, http://
www.sangoma.com.
2. Important: if the card has a four-pin power connector (a hard-drive-type
power cable commonly known as a Molex connector) connect it to an available
Molex connector.
3. Close the server’s case and reconnect the power cable.
4. Boot the server.
5. Follow the specific steps for your card below.
Digium TDM400P
The Digium TDM400P is an internal PCI card that offers from one to four analog
ports. Using the FXO daughter modules the analog ports allow you to connect
24