User guide

Time Zone
The time zone of the telephone (Hawaii, Alaska, Pacific, Arizona, Mountain,
Indiana, Central, Eastern, Atlantic). Auto configured telephones will use this
setting to automatically calculate the correct time and date.
Paging
Enabled will include this extension in the permission to be paged. Disabled will
prevent this extension from being paged.
Remote Phone
Yes configures Evolution and telephone auto configurations for remote use (a
telephone at a different location). No configures Evolution and telephone auto
configuration files for local use (default).
IP Address
For Future Use
Heartbeat
Advanced. The duration for keep-alive messages between Evolution and the
telephone (options = No, 1000, 2000, 3000, 4000, 5000).
Outbound
Internal Only permits this extension to only make internal calls (extension to
extension), Internal-Local permits this extension to make internal and local calls
(per the Outbound Dial Map route Local), Internal-Local-Toll permits this
extension to make any type of call that Evolution is configured to allow (default).
Codec
Set the CODEC to use for this extension (G711 (USA), G729 (Licensed**)). **
requires the purchase of a license, contact Intuitive Voice.
Go to http://www.cisco.com/en/US/products/sw/voicesw/ps2156/
products_user_guide_chapter09186a008008700c.html for information on how to
use the Cisco 7960 and 7940 telephones.
Polycom SoundPoint IP Telephones
The Polycom SoundPoint IP telephones may be purchased with SIP or MGCP
firmware. Evolution PBX requires SIP firmware. The following steps describe the
set up of a Polycom IP601 but the steps are similar for each of the Polycom
SoundPoint IP models. Use the following steps to set up an extension in Evolution
for a Polycom SoundPoint IP telephones. Models supported include IP650, IP601,
IP600, IP550, IP501, IP500, IP430, IP330, IP320, IP301, IP300, and the
SoundStation IP 4000.
1. Log on to Evolution and click the Resources tab at the top of the screen.
2. Click Phone Extensions in the menu on the left side of the screen.
3. At the bottom of the screen there is a drop-down menu titled New Device,
Select VoIP-Polycom-60X if you have either an IP600 or an IP601 (if you are
configuring a different model then select the appropriate Evolution device).
4. The Modify Phones detail frame will appear. Edit the following:
• Select the extension number that you want using the Extension drop-down
menu.
• Edit the Caller ID Name field to reflect what name you want to be passed
as this extension’s Caller ID text.
• Edit the Caller ID Number field to reflect what number you want to be
passed as this extension’s Caller ID number.
• Enter the MAC address from the back of the phone into the MAC Address
field (the address is twelve, hexadecimal digits).
• Select the appropriate time zone for the time zone where the phone will be
located.
• Select yes or no using the Remote Phone drop-down menu. Select yes if
the phone will not be on the same subnet as the Evolution server (for
10