User guide

Page 9 of 57
5. Select Yes if a NAT router is being used on your network or No if it is not.
6. Enter a new administrator password that will be used to log into the Web
interface once this step is complete.
7. Click Forward and the Server Settings window displays.
8. In the Server Settings window, select a 3 or 4 digit extension length for your
extensions then select the starting number for these extensions (1-9).
9. Select Enabled to enable the DHCP server built into Evolution PBX or Disabled
to disable this feature.
If in doubt regarding the DHCP server, leave it disabled. If you enable the DHCP
server, configure the following per your network:
a. Domain Name - The domain name that Evolution PBX will be handed out for
DHCP service.
b. DHCP Starting IP - The lowest IP Address that will be handed out to clients.
c. DHCP Ending IP - The highest IP Address that will be handed out to clients.
Note: You can have only one DHCP server on your LAN. Full auto discovery and
auto provisioning of some telephones require Evolution PBX to be configured as
the telephone’s DHCP server.
10. Set the time zone of the server then click Forward and the Installation Complete
window displays.
Note: Individual time zones for each telephone can be set later.