User guide
Page 6 of 57
After the first reboot a boot loader screen appears, the installation process
continues until the successful installation screen appears.
Note: This process will take approximately 7 minutes.
5. Press any key to stop the 30 second countdown and enter configuration mode.
6. Press the spacebar to configure the device.
Note: This process will take approximately 15 minutes.
7. Press Enter to reboot the server.
8. After the software loads, press any key to stop the 30 second countdown.
9. Press the spacebar to select Configure.
10. Press the spacebar to select Use dynamic IP configuration (BOOTP/DHCP)
then press the tab key to navigate to the OK button and press the spacebar to
select.
11. Press the spacebar to begin configuration.
The software configuration begins and is complete when the IP Address displays
on the screen.
12. Write down the IP Address displayed on the screen.
Note: This IP Address will be used later. If your screen does not display an IP
Address, run the netconfig command from the lockout screen (“You no longer
need to do anything directly from this console screen”) to manually configure
network settings.
UsingtheTerminalScreen
Anytime after the installation is complete there are commands that can be entered into
the terminal to configure or solve specific issues.
Note: These commands should be entered using a keyboard that is directly attached to
the Evolution PBX server on the screen displaying the message “You no longer need to
do anything directly from this console.”
TerminalScreenCommands
Command Description
debug Displays the live PBX activity on the terminal screen (helpful for
diagnostics).
g729 Installs the Digium G.729 driver and runs license wizard (must purchase
G.729 license and receive license key first). Log in to the Web interface
and reboot the server after you finish the G.729 installation.
installfax Installs Evolution PBX Fax packages.
installpika Installs the drivers for all Pika PCI cards and then reboots the server.
installrhino Installs the drivers for all Rhino PCI cards and then reboots the server.
installsangoma Installs the drivers for all Sangoma PCI cards and then reboots the
server.
netconfig Resets the server’s IP network information (IP Address, network mask,
default gateway, DNS server IP Address, and domain name).
password Resets the Web admin password to Password1!
yourout Escapes out of the Evolution PBX terminal screen to allow you to log in to
the command line interface.