User guide
Page 35 of 57
SangomaA400D
The Sangoma A400D card is modular and can accept up to 24 analog ports.
To Configure the Sangoma A400D
1. Follow the steps in the Installing Analog PCI Cards
section if your PCI card is not
already physically installed in your Evolution PBX server.
2. At the Evolution PBX server terminal screen type installsangoma to install
the Sangoma drivers (note that there are no spaces).
The server will automatically install the drivers and reboot the system.
3. Login to the Web interface and configure the card using the same information
provided for the Digium TDM400P
but select Analog-A400D rather than Analog-
TDM400P in step 3.
DigitalT1LineswithPCICards
Evolution PBX supports digital T-1 telephone lines using PCI cards. Each PCI card has a
specific pre-configuration process to install the drivers for the card but afterwards
configuration of each card type is similar.
Digital T-1 PCI Cards Description
T1/PRI-A101D Sangoma A101D PCI card for 1 T-1 digital port.
T1/PRI-A102D Sangoma A102D PCI card for up to 2 T-1 digital ports.
T1/PRI-A104D Sangoma A104D PCI card for up to 4 T-1 digital ports.
T1/PRI-R1T1 Rhino R1T1 PCI card for 1 T-1 digital port.
T1/PRI-R2T1 Rhino R2T1 PCI card for up to 2 T-1 digital ports.
T1/PRI-R4T1 Rhino R4T1 PCI card for up to 4 T-1 digital ports.
T1/PRI-TE110P Digium TE110P PCI card for 1 T-1 digital port.
T1/PRI-TE120P Digium TE120P PCI card for 1 T-1 digital port.
T1/PRI-TE210P Digium TE210P PCI card for up to 2 T-1 digital ports.
T1/PRI-TE220P Digium TE220P PCI card for up to 2 T-1 digital ports.
T1/PRI-TE410P Digium TE410P PCI card for up to 4 T-1 digital ports.
T1/PRI-TE420P Digium TE420P PCI card for up to 4 T-1 digital ports.
InstallingDigitalT1PCICards
Follow these steps if your PCI card is not already physically installed in your Evolution
PBX server.
To Install Digital T-1 PCI Cards
1. With the Evolution PBX server powered down and the power cable disconnected,
open the server’s case and insert the PCI card into one of the available PCI slots.
Refer to the card’s manufacturer for additional installation and system
requirements: http://www.digium.com
, http://www.rhinoequipment.com,
http://www.sangoma.com
.
2. Close the server’s case and reconnect the power cable.
3. Boot the server.
4. Follow the specific steps for your card below.