User guide

Page 31 of 57
12. In the Location field, select the actual location or device that you would like to
send incoming calls from each number of the VoIP account.
Note: The options that you can choose from this field change according to the
type of destination that you select in the Send Calls To field. For example, if you
choose Extensions then Evolution PBX will provide all of the extensions that you
have configured as options in the Location field. Also note that you must
configure your extension, extension group, auto attendant, or custom routing
rule before you can select it as an option in the Location field.
13. Click Save.
AnalogLineswithPCICards
Evolution PBX supports analog telephone lines using PCI cards. Each PCI card has a
specific pre-configuration process to install the drivers for the card but afterwards
configuration of each card type is similar. Evolution PBX supports FXO ports and not FXS
ports using PCI cards.
EchoTrainingandEchoCancellation
Some PCI cards include hardware echo cancellation. If your card includes hardware echo
cancellation do not use echo calibration or echo training. Echo Training listens to the
beginning of all calls made through the PCI card and establishes an amount of echo
cancellation for the duration of that call. Set Echo Training to a number that will be the
number of milliseconds that Evolution PBX will listen to the beginning of the call. Longer
times allow for a better assessment of the required echo cancellation but may be more
noticeable to the callers. Echo Training is preferred over Calibrate Echo as method of
software echo cancellation.
Analog PCI Cards Echo Cancellation Description
Analog-PIKA Yes PIKA Inline MM PCI card for up to 4 analog ports.
Analog-A200D Yes Sangoma A200D PCI card for up to 24 analog ports.
Analog-A400D Yes Sangoma A400D PCI card for up to 24 analog ports.
Analog-R4FXO Yes Rhino R4FXO PCI card for up to 4 analog ports.
Analog-TDM400P No Digium TDM400P PCI card for up to 4 analog ports.
Analog-TDM2400P Yes Digium TDM2400P PCI card for up to 24 analog ports.
InstallingAnalogPCICards
To Install Analog PCI Cards
Follow these steps if your PCI card is not already physically installed in your Evolution
PBX server.
Note: The Evolution PBX Web interface does not support FXS modules on PCI cards. Please
use external Analog Terminal Adapters such as the Linksys PAP2T-NA for easy FXS support.
1. With the Evolution PBX server powered down and the power cable disconnected,
open the server’s case and insert the PCI card into one of the available PCI slots.
Refer to the card’s manufacturer for additional installation and system
requirements: http://www.digium.com
, http://www.pikatechnologies.com,
http://www.rhinoequipment.com
, http://www.sangoma.com.
Note: Important: if the card has a four-pin power connector (a hard-drive-type power
cable commonly known as a Molex connector) connect it to an available Molex connector.
2. Close the server’s case and reconnect the power cable.
3. Boot the server.
4. Follow the specific steps for your card below.