User guide
Page 20 of 57
ConfiguringaGenericDevice(LinksysPAP2TNA)
The Linksys PAP2T-NA is a SIP analog terminal adapter. It has one RJ45 Ethernet
interface to connect to your data network and two RJ11 FXS interfaces to connect to
analog devices such as analog telephones or fax machines. Each analog port on the
PAP2T-NA must be configured as an individual extension in Evolution PBX.
To Configure a Basic Extension for Each Line of your Analog Terminal Adapter
1. Login to Evolution PBX, click the Resources tab then click Phone Extensions.
2. In the New Device field, select VoIP--GENERIC SIP- and the Modify Phones
window displays.
3. In the Extension field, select an available extension.
4. In the Caller ID Name field, enter the name you want to be passed as this
extension’s caller ID text.
5. In the Caller ID Number field, enter the number you want to be passed as this
extension’s caller ID number.
6. In the Time Zone field, select the appropriate time zone for the time zone where
the phone will be located.
7. In the Remote Phone field, select Yes if the phone will not be on the same
subnet as the Evolution PBX server (for example, if the phone belongs to a user
that is located at a remote location). Select No if this is not the case.
Note: The other options on the Modify Phones frame are optional or advanced.
8. Click Save.
Note: The Evolution PBX Web configuration interface requires that your browser’s
popup blocker be turned off or disabled so that the Device Settings screen can be seen.
9. Write down the device settings for your new extension that are displayed on the
screen. These settings will be used to configure your phone.
To Configure the Linksys PAP2T-NA Adaptor
1. Connect the Linksys PPAP2T-NA to your Ethernet network then connect an analog
telephone to one of the ports labeled PHONE 1 or PHONE 2.
2. Dial **** on your analog phone, enter 110# and the IP Address the Linksys
PAP2T-NA adaptor acquired from your network is given.
3. Write down the IP Address, open a Web Browser then enter the IP Address (for
example, http://192.168.2.71) into the Address bar.
4. Press Enter and the Info tab of the Linksys Telephone Configuration window
displays.
5. Click Admin Login, click switch to advanced view then click Line 1 to
configure the SIP settings.
6. In the Line Enable field, select yes.
7. In the SIP Port field, enter 5060.
8. In the Proxy field enter Evolution PBX’s IP Address (for example,
192.168.165.100).
9. In the Register field, select yes.
10. In the User ID field, enter the extension number (for example, 1020)
11. In the Password field, enter the password provided by Evolution PBX you wrote
down when you created your default extension.
12. In the Use Auth ID field, select No.
13. Click Save Settings and the telephone will save, reboot, and automatically
register with Evolution PBX.