User guide
Page 15 of 57
IP Address Reserved for future use
Heartbeat Advanced. The duration for keep-alive messages between Evolution PBX
and the telephone (options = No, 1000, 2000, 3000, 4000, 5000).
Outbound Internal Only permits this extension to only make internal calls (extension
to extension), Internal-Local permits this extension to make internal and
local calls (per the Outbound Dial Map route Local), Internal-Local-Toll
permits this extension to make any type of call that Evolution PBX is
configured to allow (default).
Codec Set the CODEC to use for this extension (G711 (USA), G729
(Licensed**)). ** requires the purchase of a license, contact Intuitive
Voice.
For more information on how to use the Cisco 7960 and 7940 telephones, see their user guide.
ConfiguringPolycomSoundPointIPTelephones
Polycom SoundPoint IP telephones may be purchased with SIP or MGCP firmware.
Evolution PBX requires SIP firmware. Models supported include IP650, IP601, IP600,
IP550, IP501, IP500, IP430, IP330, IP320, IP301, IP300, and the SoundStation IP 4000.
Note: All Polycom phones sent from IVT will be shipped with SIP.
To Configure a Basic Extension for Polycom SoundPoint IP Telephones in Evolution PBX
1. Login to Evolution PBX, click the Resources tab then click Phone Extensions.
2. In the New Device field, select VoIP-Polycom-60X if you have either an IP600
or an IP601 (if you are configuring a different model then select the appropriate
Evolution PBX device) and the Modify Phones window displays.
3. In the Extension field, select an available extension.
4. In the Caller ID Name field, enter the name you want to be passed as this
extension’s caller ID text.
5. In the Caller ID Number field, enter the number you want to be passed as this
extension’s caller ID number.
6. In the MAC Address field, enter the MAC Address from the back of the phone
(the address is twelve, hexadecimal digits).
7. In the Time Zone field, select the appropriate time zone for the time zone where
the phone will be located.
8. In the Remote Phone field, select Yes if the phone will not be on the same
subnet as the Evolution PBX server (for example, if the phone belongs to a user
that is located at a remote location). Select No if this is not the case.
Note: The other options on the Modify Phones frame are optional or advanced.
9. Click Save.
To Configure Polycom SoundPoint IP Telephones
1. Plug in the Ethernet cable to the Polycom phone (and the power cable too if you
are not using power over Ethernet).
2. Before the phone begins to boot it will give you the option to press Setup on the
LCD screen. Press Setup now to configure the phone. If the phone has already
finished booting up, the Setup menu can be accessed by following the steps
below:
• Press the Menu button then select Settings.
• Select Advanced then enter the password: 456.
• Press Enter and the Advanced menu displays.
3. From the Advanced menu, select Admin Settings then select Network
Configuration.
4. Scroll to and select Server Menu.