User Manual

Under-Counter Beverage Cooler
W31401000 Edition: E (Jan 2019) - 7 -
2.3 Lighting controls
●The interior light maybe switched on or off by pressing the button with the lamp
symbol that is to be found on the facia of the controller.
2.4 Eco Mode
The GSP series of coolers are fitted with some of the most energy saving
components currently available, such that even in “Normal” mode they are very
economical to run. However for further energy saving purposes during periods
of non-use, the user may select ECO mode by pressing and holding the ECO
button for several seconds until the display changes to “ECO”. When ECO mode
is selected, the following will happen:
●The controller display will show "ECO"
●The lights will be turned off.
●The internal temperature will be allowed to rise by approximately 4℃ higher than
the normal setting temperature. Caution: Do not select ECO mode if food is
being stored inside the appliance.
●Whilst the cabinet is in ECO mode, the lights may be switched on and off by use
of the light switch button.
●To return the cabinet to NORMAL mode, simply press and hold the ECO button
until the display changes temporarily to “NOR”. The refrigeration will return the
contents to the normal temperature set point .
3.0 MAINTENANCE
Please observe all of the safety warnings, precautions and instructions set out in
Section 1.
3.1 Lighting
●The appliance uses LED lighting strips powered by a low voltage transformer. If
replacement is required, please order genuine replacement parts from Rhino,
Replacement is a job for an appropriately qualified, skilled and competent
person.
3.2 Cleaning the interior and exterior
●The interior walls and shelves should be cleaned and sanitised on a regular
basis so as to ensure hygiene regulations are met. Please do not use splashing,
dripping, jetting or running water. Do not use steam. Only a damp or wet cloth
should be used in conjunction with appropriate cleaning materials for the task in
hand. Always follow the instructions specific to the cleaning materials being
used.