Use and Care Manual

10
Installing the water heater
Water Heater Energy Cover Installation Instructions
Items Provided:
1 - water heater energy cover - 34" x 78.5"
1 - water heater energy cover top - 23" Disc
1 - water heater energy cover display - 7.5" x 12"
2 - tape strips - 3" x 60"
Installation:
1. With vinyl side out, wrap the energy cover around water
heater as shown in Figure 1.
2. Apply 3 pieces of tape 6” long across cover seam as
shown in Figure 2.
3. Apply a strip of tape 32” long over entire length of seam,
as shown in Figure 3.
4. a. To attach energy cover display, pull backing off of pre-
attached tape strip and apply to front upper opening as
shown in Figure 4a.
b. From supplied tape strips, cut 3 pieces of tape 12" long
and apply to edges as shown in Figure 4b.
5. Insulate top of water heater by placing energy cover top
as shown in Figure 5.
6. Secure energy cover top to energy cover by using 4 tape
strips 6” long as shown in Figure 6.
!
CAUTION: Avoid contact with your eyes and skin.
Wear long sleeved, loose fitting clothing, gloves and eye
protection when handling fiberglass. Wash with soap
and warm water after handling.
1
4a
4b
2
5
3
6
1
2
3
4
5
6
See *Note Below
*NOTE: If enrolled in a Demand Response Program and need to
access the CTA Adaptor, cut along the perforated lines shown above
on the energy cover top.