Specifications

SYSTEM ASSEMBLY
43
6. Solar Collectors: Position the solar collectors in the correct configuration with the lower ends seated in
the collector angle / rail.
Collector Mounting
NOTE ON SCREWED FITTING CONNECTIONS
A connection with a screwed fitting uses either an O-ring or a silicone rubber washer for sealing.
Tank connection with screwed fitting – use a silicone rubber washer.
Australis collector screwed fitting – use an O-ring (supplied in all standard non TRV / OTP kits).
Titan collector screwed fitting – use a silicone rubber washer (supplied in TRV / OTP kits and single
collector kits).
7. Collector Unions: For a 300 model with two or three solar collectors, couple the solar collectors
together using the collector unions and O-rings or silicone rubber washers (screwed fitting collectors
only) supplied in the pipe kit.
(ITEMS WITH P/No's, ARE SUPPLIED IN ROOF KITS)
EDWARDS DOMESTIC SOLAR OPEN CIRCUIT GTD DESIGN
DETAIL SHEET - FOR AUSTRALIS SERIES 2 AND TITAN SERIES 2 COLLECTORS
conetite collector connection screwed collector connection
Collector Union Assembly
8. Clamps and Fixing Collector (Bottom): Ensure the solar collectors are well seated and centered in the
collector angle / rail.
Collector Rail: Loosely clamp the solar collectors (two clamps per collector) to the collector rail, using the
clamps and hex screws, washers and nuts provided.
Collector Angle: Screw the collector angle to the solar collectors (one screw per collector), using the
screws provided.